Exergy Analysis of Coal-Based 2 X 7 MW Steam Power Plant
DOI:
https://doi.org/10.31258/ijeepse.6.3.200-204
Abstract viewed: 260 times 
pdf downloaded: 282 times
Abstract
In this study, an analysis was conducted on a steam power plant system with a capacity of 2 x 7 MW based on coal. The coal fuel used by the majority of refined sizes is not in accordance with the recommendations of the American Society of Mechanical Engineers (ASME). The main objective of the study was to analyze the system components separately and to measure the exergy value of the components, covering the electrical energy so that it is known which equipment experiences the greatest energy loss as well as knowing the efficiency value of the equipment used. Efficiency and exergy are calculated using plant operation data. The results of the study found that the largest exergy destruction occurred in boilers, meaning that there was the largest energy loss in this section with a value of 37.34 MW (16.71%), while the destruction of the smallest exergy occurred in condensers of 0.58 MW (99.24%).
References
E. Hançer Güleryüz and D. N. Özen, “Advanced exergy and exergo-economic analyses of an advanced adiabatic compressed air energy storage system”, J. Energy Storage, vol. 55, 2022.
F. Tohidi, S. Ghazanfari Holagh, and A. Chitsaz, “Performance enhancement in hybrid static power generation by AMTEC–TEG systems: Energy, exergy, and interactions analyses and optimizations”, Energy Reports, vol. 8, 2022.
R. Gollangi and N. R. Kanidarapu, “A review on efficiency improvement methods in organic Rankine cycle system: an exergy approach”, Int. J. Adv. Appl. Sci., vol. 11, no. 1, 2022.
Y. Tavakol-Moghaddam, Y. Saboohi, and A. Fathi, “Optimal design of solar concentrator in multi-energy hybrid systems based on minimum exergy destruction”, Renew. Energy, vol. 190, 2022.
H. Satria, S. Syafii, and A. Aswardi, “Analysis of Peak Power Capacity on Rooftop Solar PV 1.25 kWp at Sun Conditions 90 Degrees”, Int. J. Electr. Energy Power Syst. Eng., vol. 4, no. 3, 2021.
Y. Wang et al., “Proposal and comprehensive thermodynamic performance analysis of a new geothermal combined cooling, heating and power system”, Cogent Eng., vol. 9, no. 1, 2022.
B. Haghghi, A. Saleh, H. Hajabdollahi, and M. S. Dehaj, “A combined cycle power plant integrated with a desalination system: Energy, exergy, economic and environmental (4E) analysis and multi-objective optimization”, Korean J. Chem. Eng., vol. 39, no. 7, 2022.
H. Satria, R. Syah, N. A. Silviana, and Syafii, “Sensitivity of solar panel energy conversion at sunrise and sunset on three weather fluctuations in equatorial climate”, Int. J. Electr. Comput. Eng., vol. 13, no. 3, 2023.
D. Yang, Y. Li, J. Xie, and J. Wang, “Exergy destruction characteristics of a transcritical carbon dioxide two-stage compression/ejector refrigeration system for low-temperature cold storage”, Energy Reports, vol. 8, 2022.
Y. Cui, J. Zhu, F. Zhang, Y. Shao, and Y. Xue, “Current status and future development of hybrid PV/T system with PCM module: 4E (energy, exergy, economic and environmental) assessments”, Renewable and Sustainable Energy Reviews, vol. 158. 2022.
A. B. Demirpolat, E. Aydoğmuş, and H. Arslanoğlu, “Drying behavior for Ocimum basilicum Lamiaceae with the new system: exergy analysis and RSM modeling”, Biomass Convers. Biorefinery, vol. 12, no. 2, 2022.
H. Satria, Syafii, R. Salam, M. Mungkin, and W. Yandi, “Design visual studio based GUI applications on-grid connected rooftop photovoltaic measurement,” Telkomnika (Telecommunication Comput. Electron. Control., vol. 20, no. 4, 2022.
C. Sejkora, L. Kühberger, F. Radner, A. Trattner, and T. Kienberger, “Exergy as criteria for efficient energy systems – Maximising energy efficiency from resource to energy service, an Austrian case study”, Energy, vol. 239, 2022.
Y. Wang et al., “Multi-objective planning of regional integrated energy system aiming at exergy efficiency and economy”, Appl. Energy, vol. 306, 2022.
H. Shabgard and A. Faghri, “Exergy analysis in energy systems: Fundamentals and application”, Front. Heat Mass Transf., vol. 12, 2019.
A. Rashad and A. El. Maihy, “Energy and exergy analysis of a steam power plant in Egypt”, in 13th Internation Conference on Aerospace Scieces and Aviation Technology, 2009.
S. Y. Dibazar, G. Salehi, and A. Davarpanah, “Comparison of exergy and advanced exergy analysis in three different organic rankine cycles”, Processes, vol. 8, no. 5, 2020.
W. Amjad et al., “Advanced Exergy Analyses of a Solar Hybrid Food Dehydrator,” Energies, vol. 15, no. 4, 2022.
A. Wahab, M. A. Z. Khan, and A. Hassan, “Impact of graphene nanofluid and phase change material on hybrid photovoltaic thermal system: Exergy analysis”, J. Clean. Prod., vol. 277, 2020.
W. Huang et al., “Exergy-environment assessment for energy system: Distinguish the internal and total exergy loss, and modify the contribution of utility”, Energy Convers. Manag., vol. 251, 2022.
M. B. Ledari, Y. Saboohi, A. Valero, and S. Azamian, “Exergy analysis of a bio-system: Soil–plant interaction”, Entropy, vol. 23, no. 1, 2021.
